Too Much End Play
#1
I put the engine back together and measured the end play. It says the good range for the end play is .0016 to .0028(in) with .0035(in) as being the max. But i have end play of .0069(in). The larges space that i could get is the S space which is only .3197(in)> the V spacer that i have now is .3157(in).
.0097 - .0057 = .0040. (can get with S spacer)
.0069 -.0022 = .0047 (need)
.0069 -.0035 = .0034 (max limit)
What options do I have ?
.0097 - .0057 = .0040. (can get with S spacer)
.0069 -.0022 = .0047 (need)
.0069 -.0035 = .0034 (max limit)
What options do I have ?
#3
Originally Posted by rx7love' date='May 13 2002,14:56
BIG PROBLEM......I read the indicator wrong its 0.069(In)
and the spacer is 0.3165(in) thats is way to much end play. what should i do?
and the spacer is 0.3165(in) thats is way to much end play. what should i do?
#4
There is way to much end play so I'm thinking that one of the bearings are worn.Either the the rear gear bearing, front gear bearing, or the thrust needle bearings. Since there aren't any measurements for how thick they are i'm lost.
Do you usually have to replace the thrust needle bearing when rebuilding the engines? I'm getting 0.069(in) endplay when the max is 0.0035(in). Any insight will be helpful.
Thanks
Do you usually have to replace the thrust needle bearing when rebuilding the engines? I'm getting 0.069(in) endplay when the max is 0.0035(in). Any insight will be helpful.
Thanks
#5
Originally Posted by rx7love' date='May 14 2002,21:21
There is way to much end play so I'm thinking that one of the bearings are worn.Either the the rear gear bearing, front gear bearing, or the thrust needle bearings. Since there aren't any measurements for how thick they are i'm lost.
Do you usually have to replace the thrust needle bearing when rebuilding the engines? I'm getting 0.069(in) endplay when the max is 0.0035(in). Any insight will be helpful.
Thanks
Do you usually have to replace the thrust needle bearing when rebuilding the engines? I'm getting 0.069(in) endplay when the max is 0.0035(in). Any insight will be helpful.
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)