Swapping A Series 5 Afm Into A Series 4 Rx-7!
#11
Originally Posted by 86fc3sMatt' post='783947' date='Dec 4 2005, 10:29 PM
hmm... did the mod from s4 to s5... doesnt want to idle right. it will die if i let off gas and when i start to go it sounds like it only runs on one rotor... but after like 2 minutes with my foot on the gas it will idle decently
this sounds like an idle issue. When you hold your foot on the accelerator to keep the motor running, what rpm are you at? if your around 750 then you need to set TPS and idle.
#15
Is it the same electronically?
I mean, would it be a direct swap for s5 owners to test the "the afm is too small to make good power" debate I see so often on the other board?
I ask because my brother drives a 96 MX-6 so I could possibly do a back-to-back dyno if they are directly swappable.
I mean, would it be a direct swap for s5 owners to test the "the afm is too small to make good power" debate I see so often on the other board?
I ask because my brother drives a 96 MX-6 so I could possibly do a back-to-back dyno if they are directly swappable.
#16
Originally Posted by Tessai' post='784617' date='Dec 7 2005, 03:55 PM
Is it the same electronically?
I mean, would it be a direct swap for s5 owners to test the "the afm is too small to make good power" debate I see so often on the other board?
I ask because my brother drives a 96 MX-6 so I could possibly do a back-to-back dyno if they are directly swappable.
yes, the 626/probe-mx6 afm is bigger and plugs right in and works fine, its been done!
#18
Originally Posted by CrassFC3S' post='784713' date='Dec 7 2005, 10:43 PM
so the wiring would have to be altered for a s4 correct j9? if it is a direct swap with the s5
yes, the 626/mx6/probe afm is an s5 but larger
Thread
Thread Starter
Forum
Replies
Last Post
joshuawheat
Rotary Engine Building, Porting & Swaps
4
11-25-2012 05:49 PM
The Autoholic
2nd Generation Specific
5
09-04-2005 12:06 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)