2nd Generation Specific 1986-1992 Discussion

Stoopid question

Old Jul 27, 2008 | 03:28 PM
  #1  
krazy13's Avatar
Thread Starter
Member
 
Joined: May 2007
Posts: 50
From: Lompoc, Ca
Default

Ok... 87 2+2... Is there a way to adjust the brake bias? I.E. balance between front and back? I want to adjust the brakes so the front brakes give more pressure than the back.



Also... Second question... I randomly get squealing out of the rear passenger side brakes. I have tried bleeding the brakes to remove possible air in the line to see if that was it but nothing. For the record this happens after being at a dead stop. Also happens at random when driving around. Brake pads are relatively new I had replaced them about 4 months ago. I am so stumped about that. Should I bleed them again? Should I replace the pads? Replace the rotor?



Thanks guys (in advance)
Old Jul 27, 2008 | 10:18 PM
  #2  
j9fd3s's Avatar
Senior Member
 
Joined: May 2002
Posts: 22,465
From: California
Default

do you have the same kind of brake pads all the way around? stuck caliper? bad master?
Old Jul 29, 2008 | 05:40 PM
  #3  
krazy13's Avatar
Thread Starter
Member
 
Joined: May 2007
Posts: 50
From: Lompoc, Ca
Default

no BUT... the back two sets are all raybestos. I had to replace the back brakes so I did them all...
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
banzaitoyota
Insert BS here
12
Jan 3, 2006 07:12 PM
roadkill669
Kills
3
Sep 21, 2003 04:53 PM
Rotaryman88
2nd Generation Specific
3
Jun 30, 2003 10:20 AM
9BASE3
Insert BS here
10
May 10, 2003 05:42 PM
DoceA
1st Generation Specific
5
Jul 27, 2002 10:35 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Thread Tools
Search this Thread

All times are GMT -5. The time now is 07:38 AM.