Removed My Motor..
#1
Where'd it gooooo
Ahh.. there it is..
found it!.. now the reason why i pulled it..
naughty front rotor.. nauughtttyy
This was my evening well not all of it but a little bit of time. Thanks to dr0x for hooking me up with some wrench sizes for those pesky oil lines & for telling me to remove my exhaust manifold to take some pics of those beauties. now to wait for all the new parts to arrive It will be fun in a week.. oh yes it will
Ahh.. there it is..
found it!.. now the reason why i pulled it..
naughty front rotor.. nauughtttyy
This was my evening well not all of it but a little bit of time. Thanks to dr0x for hooking me up with some wrench sizes for those pesky oil lines & for telling me to remove my exhaust manifold to take some pics of those beauties. now to wait for all the new parts to arrive It will be fun in a week.. oh yes it will
#6
to be honest I did it from the Mazda mount on the front of the motor.. I'ld recommend two people if you do it this way after doing it all by myself yesturday. I just put some pressure on the motor.. and lifted it a little myself.. then it's a matter of making sure when you pull it off the input shaft that you pulling it evenly.. I was having troubles at first because the bottom seperated more than the top did once I figured that out i corrected it with some lanky muscle power and she slipped right off. Cranked up the cherry picker and carefully moved the motor over the chassis and set her down I'll probably set it in the car the same way but with another person to control the cherry picker and just use muscle power to line the motor up with the input shaft.
Thread
Thread Starter
Forum
Replies
Last Post
RX73rdgen
3rd Generation Specific
13
02-01-2003 11:58 AM
DJ Rotor
2nd Generation Specific
6
10-29-2002 12:07 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)