Rats nest removal gone wrong....
ever since i removed the rats nest and swapped manifolds
basically there is no idle ...and i cant get above 2k rpms....: ( it wont start unless its push started ....and the 2ndary rail only get fuel in it but when i pull return hose ...nothing ....just air....ive done everything i could think of....
fuel pump is pumping*
tps sensor *
CAS *
check vac leaks*
everything hooked up*
all vacs capped*
MAF*
checked fuel pump*
jumpered EFI *
pulled it apart checked again...re did it followed each step from the FAQ...
still nothing ....im just stuck ...lol its some sort of fuel issue i guess b/c their is no fuel in the rail .(or at least not engouh to start the car..)
basically there is no idle ...and i cant get above 2k rpms....: ( it wont start unless its push started ....and the 2ndary rail only get fuel in it but when i pull return hose ...nothing ....just air....ive done everything i could think of....
fuel pump is pumping*
tps sensor *
CAS *
check vac leaks*
everything hooked up*
all vacs capped*
MAF*
checked fuel pump*
jumpered EFI *
pulled it apart checked again...re did it followed each step from the FAQ...
still nothing ....im just stuck ...lol its some sort of fuel issue i guess b/c their is no fuel in the rail .(or at least not engouh to start the car..)
Thread
Thread Starter
Forum
Replies
Last Post
BlownSE
1st Generation Specific
11
Mar 20, 2005 09:43 PM
REFLUX
2nd Generation Specific
13
Dec 17, 2004 11:21 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)



