I would like to know what all is involved with attempting the rats nest removal on the GSL-SE model RX-7's. I would think that there is quite a bit more to removing it than...removing it.



For example, what definitely needs to be left in place? What, if anything, needs to be capped off? Will there be a loss of any of the car's features (read cruise control and others)?



Any other information is appreciated, as well as any links to such a write-up.



Thanks.

 

wow i didnt think second gens even had a rats nest. i always thought it was part of the FDs nasty *** sequential tt system

 

ok ur in the 1st gen section....and all rx7s do



mike =

 

fuc# that shizbot im tired. sorry mazderati im messin up ur post but mike smells like kaky and i dont like him

 

Relax Mikes!



GSL-SE = EFI 13B, it has a rats nest basically the same as the S4 N/A FC's, no? ...



GSL-SEs are late model FB's with what was to become the FC's new powerplant, other 1st gens have the carbed 12A..



Mazderati I'm sure the mod is not unlike anything you read about in the 2nd gen forum? Perhaps take a peek there?

 

Check the FAQ's.



Here's the link to the link.



https://www.nopistons.com/forums/ind...howtopic=14337

 

so is the rats nest the same for the s4 and the gsl-se? i need a detailed explanation of what to remove, and all the ones ive found for fbs are for 12as.

 

a post from the 2004!



yes the only ones I've seen are for 12a's.



As a side note, the tutorial no longer exists. If anyone finds one, post it up.

 

this link works, its a pretty good tutorial but its for a 12a. http://maz_tutorials.ten15.net/Tutorial_1_print.pdf

 

woo hoo.... i needed taht link for my project!! THANKS Shane