Does anyone out there know the thread size and pitch for the hoses where they screw into the power rack? I'm planning on taking out all of that ****, and need to know the thread size before I do it.

 

I tried finding bolts that matched up at the hardware stores in the area and failed miserably, what I ended up doing was taking one of the lines on the rack that goes to the valve and bending it around so it lined up with the other side of the piston to loop it. Then I just cut all the other lines nice and short, took em in and welded the line's shut w/ a small mapp+oxygen torch so they're plugs now. On the banjo bolts I welded the hole at the end of the bolts shut and cut the banjo lines short and just used the banjo piece as a spacer to keep the bolts clearanced.





total cost: $0.00



already had the torch, flux, and filler rod.