Ever since I've done the turbo conversion, my logicon and blower motor hasn't been working.



However, when pulling my tranny out, for some reason my logicon and blower started working. It wasn't until the tranny and the starter were completely out (all wires disconnected) that the damn thing worked.



Now that my tranny is back in, it doesn't work anymore. I've tried to recreate the conditions several times with no luck. I assume its a wire incorrectly hooked up, or a ground connected wrong.



I'm at a loss and need a little help.



Thanks,

Mike

 

I dunno, but on the my other convertible, the blower and what not sometimes doesnt work unless I wiggle the key in the ignition a bit? Try that?

 

theres a couple of plugs under the dash that i had wrong, to do the same thing. i think the other one was for the front amp?



mike

 

hmmm, I think I have a shorted wire somewhere. I keep blowing my wiper fuses. I went ahead and pulled out all the A/C stuff today, in order to check everything. I'll probly leave it out until after I run the 1/4 tomorrow.