Ok Everyone Need Help Bad!

Reply Subscribe

Thread Tools

Search this Thread

07-28-2005, 05:03 PM

#21

RONIN FC

Senior Member

Join Date: Oct 2003

Location: Boston Ma.

Posts: 1,420

If your sure the compression is good, do like Shane said. But pay close attention to the primary injectors and their wireing.

07-31-2005, 04:57 PM

#22

1Revvin7

Senior Member

Join Date: Oct 2001

Location: Peoria, AZ

Posts: 10,906

This could be a whole list of problems. Where are you located, maybe you live near someone who could give you a hand...

07-31-2005, 05:47 PM

#23

darrinstrunk

Member

Thread Starter

Join Date: Jul 2005

Location: Toledo

Posts: 38

[quote name='1Revvin7' date='Jul 31 2005, 05:57 PM']This could be a whole list of problems. Where are you located, maybe you live near someone who could give you a hand...

[snapback]744258[/snapback]

[/quote]

i live in boo foo Toledo Ohio....the local mazda dealer doesnt even have a manual to use for themselves...so i am pretty much screwed....

..new development though, maybe this'll help narrow it down: when i turn on any electrical components, ie...lights, wipers, hazards...the car chokes out....does this help?

07-31-2005, 11:05 PM

#24

darrinstrunk

Member

Thread Starter

Join Date: Jul 2005

Location: Toledo

Posts: 38

[quote name='darrinstrunk' date='Jul 31 2005, 06:47 PM']i live in boo foo Toledo Ohio....the local mazda dealer doesnt even have a manual to use for themselves...so i am pretty much screwed....

..new development though, maybe this'll help narrow it down: when i turn on any electrical components, ie...lights, wipers, hazards...the car chokes out....does this help?

[snapback]744269[/snapback]

[/quote]

checked fuel pump, its fine checked coil packs with an ohmeter all 3 were less than an ohm so it ain't them. also, checked the alterntor and it's fine.......

I AM OFFICIALLY :

{{{{{{{{{{{{clueless}}}}}}}}}}}}

08-01-2005, 10:44 AM

#25

Shane.Trammell

Senior Member

Join Date: May 2002

Location: Richardson Texas

Posts: 4,326

how did you check the alternator?

the way it sounds it could be the BAC. the bac is supposed to allow extra air in when there is a load on the engine. is there a bac on FDs?

08-01-2005, 10:50 AM

#26

ColinRX7

Senior Member

Join Date: Oct 2003

Location: Canada

Posts: 3,502

Add a new battery ground from the negative terminal to the chassis, and inspect or add a strap that goes from the engine block to the chassis.

I don't know how many power issues or rough idle issues I've seen caused by decaying factory grounds as the car ages..

I thought I had a dead motor on one RX7 until I added a new ground...