Nitrous
#1
Im thinking about running some nitrous but im not sure.Anyone here running nitrous on their n/a or turbo fc?What make and how much hp is the shot?What kind of mods did you do to run the kit safely?Is it a dry or wet kit?How much nitrous can these rotary engines handle?
#2
I had an 83 that I ran a 150 shot on. Mods were: ported 13B 4 port from an RX4 with S5 N/A rotors, factory apex seals from Racing Beat. It had the Racing Beat Holley intake manifold with a 650 double pumper, Racing Beat header with silencer and Magnaflow muffler. Also had 2 Msd 6A ignition boxes. I switched the plugs to platinum NGKs and went a step colder in both postitions. I never had the car professionally dynoed but here (6000 feet) my best times were in the very low 12's, so I would guess the car was making about 300hp. I used it for a daily driver too until the motor popped, and it did that only because of a bad mistake. At the strip I went to shift from 3rd to 4th and the tranny dropped into 2nd instead and the motor went bye bye Fun car though.
#3
I tune a LOT of nitrous systems for rotaries.
I exclusively use NX and NOS brand, anywhere from 30hp-400hp shots.
Mods required depend on the desired power, and what other mods exist on the car.
I exclusively use wet kits on RX-7's.
I have thrown 300 hp of nitrous into a stock 13B engine.... There is next to nothing required for internal upgrades to the ENGINE.
How about you tell me what you have for a car, what kind of power you're looking for (RWHP under nitrous), your budget, and what existing mods you have?
I exclusively use NX and NOS brand, anywhere from 30hp-400hp shots.
Mods required depend on the desired power, and what other mods exist on the car.
I exclusively use wet kits on RX-7's.
I have thrown 300 hp of nitrous into a stock 13B engine.... There is next to nothing required for internal upgrades to the ENGINE.
How about you tell me what you have for a car, what kind of power you're looking for (RWHP under nitrous), your budget, and what existing mods you have?
#4
#5
[quote name='RE87FC' date='Aug 12 2005, 11:57 AM']I had an 83 that I ran a 150 shot on. Mods were: ported 13B 4 port from an RX4 with S5 N/A rotors, factory apex seals from Racing Beat. It had the Racing Beat Holley intake manifold with a 650 double pumper, Racing Beat header with silencer and Magnaflow muffler. Also had 2 Msd 6A ignition boxes. I switched the plugs to platinum NGKs and went a step colder in both postitions. I never had the car professionally dynoed but here (6000 feet) my best times were in the very low 12's, so I would guess the car was making about 300hp. I used it for a daily driver too until the motor popped, and it did that only because of a bad mistake. At the strip I went to shift from 3rd to 4th and the tranny dropped into 2nd instead and the motor went bye bye Fun car though.
[/quote]
Ohh that's ruff man sorry to hear that.
[quote name='scathcart' date='Aug 12 2005, 06:38 PM']might also want to start by reading this:
https://www.nopistons.com/forums/ind...howtopic=18809
[/quote]
Good write up!
[snapback]747931[/snapback]
[/quote]
Ohh that's ruff man sorry to hear that.
[quote name='scathcart' date='Aug 12 2005, 06:38 PM']might also want to start by reading this:
https://www.nopistons.com/forums/ind...howtopic=18809
[snapback]748036[/snapback]
[/quote]
Good write up!
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)