Wich bolt loosesn ths Crank angle sensor? And What pin do I line up the marks to?

 

There is a pin that should be sticking out of the engine right behind the eccentric shaft pulley. There is one small nut that is in a slot on a bracket next to the CAS. Loosen this nut enough to move the CAS.

 

ok, I see the pin, but that nut that you loosen, is like on a slider where you can move the CAS back and forth, well there isnt a nut there its like a round pice of rubber with a pice or metal sticking out of it. Or am i looking at the wrong thing?

 

That sounds like the right place. The CAS is near the left front of the engine near the power steering pump and airconditioning pump if you have one. Mine has the slider but there is a nut on top to loosen. Yours sounds a little different Maybe someone else can chime in with a little more info.

 

Ok, I thought the nut was broken but it doesnt look broken.

 

they put a little plastic thing over the nut/bolt



mike

 

oh ok,