More Header Problems
#11
if something can go wrong while I'm working on it, it will go wrong
shopping list:
pulsation damper
lower to upper intake gasket
little gasket kits for the injectors
anything else?
until I get the stuff, will it be ok to wipe off the area each time I have to go somewhere, or should I just not drive it at all? (scheduled to rain this week...motorcycle + rain = not very fun)
shopping list:
pulsation damper
lower to upper intake gasket
little gasket kits for the injectors
anything else?
until I get the stuff, will it be ok to wipe off the area each time I have to go somewhere, or should I just not drive it at all? (scheduled to rain this week...motorcycle + rain = not very fun)
#12
Originally Posted by Baldy' date='Feb 5 2003, 08:37 PM
if something can go wrong while I'm working on it, it will go wrong
shopping list:
pulsation damper
lower to upper intake gasket
little gasket kits for the injectors
anything else?
until I get the stuff, will it be ok to wipe off the area each time I have to go somewhere, or should I just not drive it at all? (scheduled to rain this week...motorcycle + rain = not very fun)
shopping list:
pulsation damper
lower to upper intake gasket
little gasket kits for the injectors
anything else?
until I get the stuff, will it be ok to wipe off the area each time I have to go somewhere, or should I just not drive it at all? (scheduled to rain this week...motorcycle + rain = not very fun)
#14
so I guess I want the injector o-ring, as it's called: http://www.mazdatrix.com/c-6.htm
the site says the location is "top," is that all I need?
the site says the location is "top," is that all I need?
#16
this is my shopping cart
pulsation damper
gasket intake- center
injection o-rings
injection upper grommet
injection lower grommet
I didn't see anything called a middle one...just top and bottom grommets, and top o-rings
I have a haynes manual...should that be good enough for this task? (even though I'll probably refer to you guys about 23 million times by the time I'm done)
pulsation damper
gasket intake- center
injection o-rings
injection upper grommet
injection lower grommet
I didn't see anything called a middle one...just top and bottom grommets, and top o-rings
I have a haynes manual...should that be good enough for this task? (even though I'll probably refer to you guys about 23 million times by the time I'm done)
#20
Yea, you will need the injector o-ring and then the upper and lower grommets. The thing I like about VictoriaBritish is that they sell an injector seal kit. Each kit contains two o-rings, two sets of grommets and two sets of dust boot thingies, all for 10.95. .