Ok new problem. I hooked up the clutch, flushed it, blead it, primed it, it felt great. I got to start her up it smoked alittle very loud (no dp) I turned it off and the clutch petal is on the ground. So I figured somethings loose, not the case. I can pump it up and it builds good preasure, but I hold it down fer a few secs and I can see the little piston that pushes fork go back slowly. I changed the piston thingy and still does same thing, so its not that. WHAT COULD IT BE???





I was thinking it was the Clutch master cylinder is leaking preasure, please help I wanna drive.

 

Yeah, if everything is leak free then it sounds like a bad master cylinder.

 

Thank you I needed conformation b4 I got a new 1

 

If the slave cylinder is good then make sure that your clutch hose isn't leaking.

 

Geez, sounds like it turned out to be quite the chore!

 

Yeah.... but I could put another in alot easier now 1st times the worst, plus I learned lot about my car.