Installing S4 Jspec Intakes
#1
http://www.rx7club.com/showthread.ph...hreadid=298687
There is the main thread if someone could help me out here.
There is the main thread if someone could help me out here.
#6
Two holes line up on mine Either one of the outer two stud holes.
Then the other three are off.
But let's not forget about matching the runners. I'm probably going to have to drill all new holes or something for the sake of the runners matching. I don't care about an 'easy' bolt on. My upper is already port matched for a TII lower.
Then the other three are off.
But let's not forget about matching the runners. I'm probably going to have to drill all new holes or something for the sake of the runners matching. I don't care about an 'easy' bolt on. My upper is already port matched for a TII lower.
Thread
Thread Starter
Forum
Replies
Last Post
mazdaspeed101
2nd Generation Specific
25
11-09-2002 10:10 PM
OKIERX-7
2nd Generation Specific
29
09-15-2002 05:28 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)