I need some help...
#1
Ive got an 87 GXL and my clutch is going on me. I want to get an upgraded clutch and fly wheel. What would be a good one for my car? Also my shifter is really really loose. There is too mush play in it when Im in gear. I think I need some new bushings. Is this my problem? If it is where can I get some bushings for my car for a reasonable amount of money?
#2
I've heard that an '89 on up pressure plate and clutch disk provide more clamping force than you stock setup, or a centerforce pressure plate, but still use an '89 on up stock disk. That is definetly a bushing problem, get them from a local mazda dealership. Don't forget the new throw out and pilot shaft bearings as well
#4
You also might want to get the lower shift boot. These seem to wear out just as frequently. This will help: http://www.rx7world.com/ht1.htm
Thread
Thread Starter
Forum
Replies
Last Post
nopistons94
3rd Generation Specific
11
05-11-2007 10:13 AM
1987rx7guy
Interior, Exterior, Audio Mods
1
06-24-2003 07:19 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)