I was just wandering if anyone has heard flowmasters on any rx7? I'd like to get a header and just run a straight pipe to the dual flowmasters, since they cancel sound frequencies for legal reasons but still give you decent horsepower. Give me your opinions thanks..

 

they supposidly sound like crap and wont hold up

Flowmaster themselves say not for use on rotaries

 

ok, what mufflers do hold up that aren't extremely loud or exspensive.

 

depends on your definition of loud, or expensive

 

i wanted to go with magnaflow for my car, but i dunno...

 

loud being the usual crackle of a straight through rotary with a header...i just want to tone it down a little. And exspensive being like under 300 for a cat back system.

 

the dynomax system might be a good bet for under $300

corksport is 300, but its loud

 

I too was wondering about something like this.



I'd like to have a custom catback made, ending with an Apexi N1 fart cannon, but I want something quiter.



I was wondering about a flowmaster, but if they burn out on rotaries, then no thanks...



Any advice on a resinator and high flow cat combo to keep it quiet?

 

racing beat is louder, but not that loud...

 

BORLA mufflers fukin own, and in the nopistons store there is a 2nd gen cat back all stainless steel for 370. 1 million mile warranty. That is a solid setup for cheap considering two borla mufflers would cost you that much alone.



and don't do the corksport cat back if your n/a. You WILL be arrested. I had that setup but refused to drive anywhere with it.