I was just wandering if anyone has heard flowmasters on any rx7? I'd like to get a header and just run a straight pipe to the dual flowmasters, since they cancel sound frequencies for legal reasons but still give you decent horsepower. Give me your opinions thanks..
|
they supposidly sound like crap and wont hold up
Flowmaster themselves say not for use on rotaries |
ok, what mufflers do hold up that aren't extremely loud or exspensive.
|
depends on your definition of loud, or expensive
|
i wanted to go with magnaflow for my car, but i dunno...
|
loud being the usual crackle of a straight through rotary with a header...i just want to tone it down a little. And exspensive being like under 300 for a cat back system.
|
the dynomax system might be a good bet for under $300
corksport is 300, but its loud |
I too was wondering about something like this.
I'd like to have a custom catback made, ending with an Apexi N1 fart cannon, but I want something quiter. I was wondering about a flowmaster, but if they burn out on rotaries, then no thanks... Any advice on a resinator and high flow cat combo to keep it quiet? |
racing beat is louder, but not that loud...
|
BORLA mufflers fukin own, and in the nopistons store there is a 2nd gen cat back all stainless steel for 370. 1 million mile warranty. That is a solid setup for cheap considering two borla mufflers would cost you that much alone.
and don't do the corksport cat back if your n/a. You WILL be arrested. I had that setup but refused to drive anywhere with it. |
All times are GMT -5. The time now is 04:12 AM. |
© 2024 MH Sub I, LLC dba Internet Brands