Fd Manifolds On An Fc

Reply Subscribe

Thread Tools

Search this Thread

03-08-2004, 11:46 PM

roadkill669

Senior Member

Thread Starter

Join Date: Jun 2003

Location: Culpeper, VA

Posts: 572

I tried a search but came up with nothing. What exactally needs to be done

03-08-2004, 11:50 PM

FikseRxSeven

Senior Member

Join Date: Jan 2003

Location: union, new jersey

Posts: 8,079

ask thecamel

03-09-2004, 12:00 AM

bdls

Junior Member

Join Date: Feb 2003

Posts: 9

http://www.teamfc3s.org/forum/showthread.p...25&pagenumber=1

03-09-2004, 12:15 AM

roadkill669

Senior Member

Thread Starter

Join Date: Jun 2003

Location: Culpeper, VA

Posts: 572

Excellent

Thanks

03-09-2004, 05:00 AM

TheCamel

Senior Member

Join Date: May 2003

Location: Dover DE

Posts: 989

I am using a S5 LIM from a JDM motor so there may be small differences. But here are a few pics to see the porting and hole modifications I did.

Attached Thumbnails

03-09-2004, 05:01 AM

TheCamel

Senior Member

Join Date: May 2003

Location: Dover DE

Posts: 989

without gasket

03-09-2004, 05:03 AM

TheCamel

Senior Member

Join Date: May 2003

Location: Dover DE

Posts: 989

Then you just widen the holes on the end bolt holes to line up the manifold, using the center bolt hole as a guide, took me about 20 mins with the dremel. But I take my time. and these pics are not finished, I am working on the polishing of the manifold now and will finish port the UIM when done.