convertible driveshaft
#1
i have been told that the driveshaft from any convertible FC AUTO will fit the TII tranny and bolt to all NA diffs. now i know that it will bolt to NA diffs because there the same rears in all non turbo diffs.
but the shaft that enters the trans is what im not sure about, anyone know this will work?
TII trans, convertible automatic driveshaft, NA diff...?
but the shaft that enters the trans is what im not sure about, anyone know this will work?
TII trans, convertible automatic driveshaft, NA diff...?
#4
so Rob...
by any chance do you have a auto driveshaft and a TII trans handy that you can try putting the shaft into? you did your swap recently right?
J9, how much shorter? if its a small difference and the shaft still enters the tranny enough, it would still work. when i changed my NA driveshaft i measured 2 different S5's, and one S4. they were all different lengths. the most being over an inch different.
i have a TII trans handy. but no auto drive shaft to test with.
Edit: i noticed i keep writing convertible. i dont know why. i mean to write auto trans. a guy with a convertible told me this. thats probley why its stuck in my head.
by any chance do you have a auto driveshaft and a TII trans handy that you can try putting the shaft into? you did your swap recently right?
J9, how much shorter? if its a small difference and the shaft still enters the tranny enough, it would still work. when i changed my NA driveshaft i measured 2 different S5's, and one S4. they were all different lengths. the most being over an inch different.
i have a TII trans handy. but no auto drive shaft to test with.
Edit: i noticed i keep writing convertible. i dont know why. i mean to write auto trans. a guy with a convertible told me this. thats probley why its stuck in my head.
#8
#10
Originally Posted by sen2two' post='906000' date='Aug 6 2008, 03:29 PM
thanks for that link...
and according to those measures. the auto drive shaft would work with a TII trans and NA rear. but its 2.25 inches shorter.
that just might be to short.
and according to those measures. the auto drive shaft would work with a TII trans and NA rear. but its 2.25 inches shorter.
that just might be to short.
like 2" too short, its wizzard sleevery
Thread
Thread Starter
Forum
Replies
Last Post
1Revvin7
RX-7 & RX-8 Parts For Sale & Wanted
8
09-03-2002 09:52 PM
Chewbacca
2nd Generation Specific
6
07-04-2002 01:03 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)