so your positive cable goes straight to the starter then you pull your power for the accessories from the starter. or you run a separate cable to the battery?

 

thats how i did mine, + cable runs from battery to starter, then i left the factory battery harness in there.

 

cool beans

 

I'd invest in some bulkhead connectors rather than a grommet through the firewall.

 

im going to have to look into that I got the seats into the car and putting rear bins in will post some progress pics soon since i had to move

 

Making some pretty quick progress keep up the good work



Great idea with the lining and im glad you didnt go too fancy, with that **** its more about how you prep whats underneath than anything else.

 

I am going to put some more bed liner in but it is good stuff and is tough to remove so i hope it will hold up for some time. I am almost done with the wiring so it is time to start looking for a motor. I am going 13B-RE for sure and im planing on dropping the motor in as is finishing up the wiring on the motor and try to start it up. Im going to inspect the motor first outside the car and see if it needs a rebuild before i put it in, if that is the case i will scratch the idea and rebuild it first then drop it in. We will see how things go and im getting back like 3K from income tax so progress will come quick.

 

Wow 3k I got...300.

 

Some progress pics



Interior I know seats are blue and car has grey interior but it is all going to the interior man for a complete black make over













The wiring Continued









Im going to use this plug i got off my friends RX-7 to make an engine harness quick release. It is from the AC stuff of of his car.





And my old Arospeed Strut Bar

 

do you guys think that connector will be fine or what?