swap exhaust sleeves with my motor assembled?
#1
ive got a stock 20b with good compression (prepping it to drop in my FD). since everything seems ok id love to get it in the car and drive it for awhile before i rebuild it, however there is the problem of the stock exhaust sleeves. so now im looking for a method to remove them while the motor is assembled. im sure there must be a way, but from what i can tell the roll pins are difficult to remove even with the housing on a work bench.... however where there is a will, someone usually finds a way. anyone have a method for extracting the pins with the motor together? also even if i can get them out, can i install new ones from the exhaust port side once the new sleeves are in? theres gotta be a way...... -heath
Thread
Thread Starter
Forum
Replies
Last Post
blk 93
Meet and Greet
0
04-29-2009 03:34 PM
Fd3BOOST
Rotary Engine Building, Porting & Swaps
76
03-25-2003 11:37 PM
rxseven
Rotary Engine Building, Porting & Swaps
9
01-13-2003 12:34 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)