I'm palnnig a 20b setup for my fd and I have found two front cross members for the 20b swap one from hinson super cars and one from rotary specialties from canada what is going to the best choice I'm going to use an aftermarket hood as well so I want the motor to sit as low or lower than the 13brew did. any information is greatly appreciated. thanks in advance

 

i take it ya swaping the front cover for a 13b one to get it front mounted or are your talking about the front subframe?

 

i was talking about the front subframe

 

Call these guys for the conversion Kit.



Defined Autoworks

Here is our address- 12157 Broad st. Pataskala, Ohio 43062



Phone number- #614-592-7991



Doesn't require a different subframe, and you don't move the rack. By far the most elegant solution i have seen, they were just 6 months too late for me.

 

web site link?

 

if you dont have to change the front crossmember and and it stays in the same position dont you have to cut the firewall, or relate the tranny or something?

 

If you go dry sump and lower the intake bit I think it's possible to leave the steering rack where it is and not having to cut the firewall..