exhaust sleeves (stupid question)
10-21-2006, 12:01 AM
#1
Junior Member
Thread Starter
Join Date: Oct 2006
Posts: 16
Probably going to be flamed for this one but here goes. 
Is there any reason why the exhaust sleeve locating pins can't be removed by drilling the Ali housing away above them, then when replaced the area rebuilt with chemical metal? Reason being the 20b in my Cosmo still has the stock sleeves in place that i wan't to replace but compression is good and the motor running well so i didn't want to strip the engine just yet.
Kevin
Is there any reason why the exhaust sleeve locating pins can't be removed by drilling the Ali housing away above them, then when replaced the area rebuilt with chemical metal? Reason being the 20b in my Cosmo still has the stock sleeves in place that i wan't to replace but compression is good and the motor running well so i didn't want to strip the engine just yet.
Kevin
Thread
Thread Starter
Forum
Replies
Last Post
1Revvin7
Rotary Engine Building, Porting & Swaps
13
05-18-2005 08:52 AM
'79rx7
Rotary Engine Building, Porting & Swaps
3
04-26-2004 05:04 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)