rx-8 13b 6 port
#11
the 6 port are 236 flywheel i think. and the 4 port are 198. i think also. im not 100% sure there...
either way, equal to, or more than a TII swap with better gas milage and instant power. no lag.
since your going carb, you'll need to use the 12a dizzy and timing gear. along with 12a front cover like i said earlier. theres nothing worng with going carb. but i dont like it cause theres always a comprimise somewhere in tuning. anyways. megasquirts are cheap ECU's. and a 2nd gen CAS = crank angle sensor. where the dizzy = distributor goes. so i can use FC ignition set up on the renesis.
either way, equal to, or more than a TII swap with better gas milage and instant power. no lag.
since your going carb, you'll need to use the 12a dizzy and timing gear. along with 12a front cover like i said earlier. theres nothing worng with going carb. but i dont like it cause theres always a comprimise somewhere in tuning. anyways. megasquirts are cheap ECU's. and a 2nd gen CAS = crank angle sensor. where the dizzy = distributor goes. so i can use FC ignition set up on the renesis.
Thread
Thread Starter
Forum
Replies
Last Post
TweakGames
Rotary Engine Building, Porting & Swaps
25
10-14-2007 12:10 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)