Will the stock nikki carb work until I get something better? I have a project underway, an 83 gs that I wanna put a 12a streetport in. I'll later upgrade to a weber/dellorto sidedraft but the project will probably sap my funds for awhile.



Thanks guys.

 

yah it'll run, just run out of steam a little faster



mike

 

I was thinking that. I'm looking at getting it all put together, then dropping some cash on the RB upper manifold for the weber/dellorto and buying a weber dcoe or dellorto dhla similar to this one:



http://cgi.ebay.com/ebaymotors/ws/eBayISAP...&category=33550



Along w/ RB Header and street/strip clutch & pressure plate.

Also, what all of the "rats nest" is required? I want the install to be as simple as possible.



Anything else I should pick up ?

 

Also, is a 40mm Dellorto going to be enough? Or should I go with something like a weber 45 dcoe ? dellorto 48 dhla?

 

I just rebuild and streetported my 12a, and im still using the stock nikki.

It runs fine.

 

The 40mm is way too small for a streetport. 45mm is good for stock port, and a small street. But if you want to get all the power out of a streetport go with the 48mm.