Peripheral Porting
#1
Where can I have 12a housings peripheral ported? I would rather not buy new ones already done. Anyone know the correct diameter hole to use? How about a carb setup to accomodate? Fuel pump? All info is appreciated!
#2
the carb/efi is easy you need a 48ida weber, or they have 48ida efi throttle bodies. the factory pp race cars have 3 fuel pumps with a surge tank (they had the 79 insa gtu car at sevenstock).
on a 13b you can buy racing beat housings cheaper than you can have one made, but on a 12a the factory ones are the only ones you can get. the problem with a diy is the port timing, theres no published specs for the pp housings so nobody knows where to put the hole
mike
on a 13b you can buy racing beat housings cheaper than you can have one made, but on a 12a the factory ones are the only ones you can get. the problem with a diy is the port timing, theres no published specs for the pp housings so nobody knows where to put the hole
mike
#5
Originally Posted by Heath' date='Apr 17 2003, 06:39 PM
So the Weber would be the carb of choice? I can't find a used 48ida on Ebay. Are there any other carbs that would work and are reasonably priced?
mike
Thread
Thread Starter
Forum
Replies
Last Post
DJ Rotor
Rotary Engine Building, Porting & Swaps
32
04-10-2003 12:14 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)