I pulled the front cover bolts and oil pan bolts but theres still a tight hold on it by the AC bracket studs.What esle holds it on?It says 6 bolts but those are pulled already and theres no dizzy on it.
Luis |
the 19mm front pulley bolt?
mike |
Thats been off for awhile now.Its attached at the dowel pin area right by where the dizzy sits.Stupid engine is starting to annoy me. https://www.nopistons.com/forums/pub...IR#>/angry.png I have the 6 bolts out the pulley off the oil pan bolts off and still stuck.Tried cranking it with a rubber mallet and nothing.Its held together to tight and don't want to crack the cover so I have to figure something else out.
|
theres a hidden bolt! under the grease
mike |
I'm going with Mike on this one
|
Originally Posted by setzep' date='Apr 30 2003, 06:14 PM
I'm going with Mike on this one
mike |
theres 2 pins that holds it in place u may have to use a flathead screwdriver or a prybar to separate it from the engine .
|
Originally Posted by j9fd3s' date='Apr 30 2003, 10:12 AM
theres a hidden bolt! under the grease
mike |
Originally Posted by rotary fury' date='Apr 30 2003, 07:19 PM
theres 2 pins that holds it in place u may have to use a flathead screwdriver or a prybar to separate it from the engine .
|
ARG!Its at the dowel pin on the opposite the oil metering pump.What is holding it tight there?Nothing is mentioned in the manual of a 7th bolt holding it there. https://www.nopistons.com/forums/pub...IR#>/angry.png https://www.nopistons.com/forums/pub...IR#>/angry.png https://www.nopistons.com/forums/pub...IR#>/angry.png https://www.nopistons.com/forums/pub...IR#>/angry.png
|
All times are GMT -5. The time now is 05:50 AM. |
© 2024 MH Sub I, LLC dba Internet Brands