Cf Taillamp Center Piece
#21
My center panel is curving/bowed outward in the center due to age, temperature extremes, and how rigidly they are attached. I'd like to replace it, either with a straight factory one, or a clear or CF one.
ioTus: Sounds good to me, I'll probably do it this Winter unless I come across a set cheap on eBay to send you...
ioTus: Sounds good to me, I'll probably do it this Winter unless I come across a set cheap on eBay to send you...
#22
hey iotus, there's also ways to clear the taillights on you own, and get colored bulbs for the housings, i've seen it on cars like this one. I dont personally find it appealling, but maybe you all will.
Also regarding the CF rear peices, I can do it, but it would cost around 300, I would suggest buying carbon fiber decal and CAREFULLY applying it to you rear center peices. To fix the warping problem you must carefully heat them in an oven at a low heat for several hours to let them settle back flat...its very complex process though and no room for error since new peices go for 200 ea, thats $600 across the back of the car.
Also regarding the CF rear peices, I can do it, but it would cost around 300, I would suggest buying carbon fiber decal and CAREFULLY applying it to you rear center peices. To fix the warping problem you must carefully heat them in an oven at a low heat for several hours to let them settle back flat...its very complex process though and no room for error since new peices go for 200 ea, thats $600 across the back of the car.
#26
im just saying that because my center piece is bowing outward and a cf sticker wont fix that, plus i think it would be better if it was just a flat panel without the ridges....and not $300
#28
Originally Posted by ioTus' date='May 5 2004, 05:08 AM
whast your email adress. I have a center piece sitting right here, I can take any picture you need. I have a bunch taken already, w/ a tape measure up against them. They are in a ZIP file, just need your email addy, mine is:
gjensen@pullman.com
gjensen@pullman.com
Thread
Thread Starter
Forum
Replies
Last Post
hsmidy
Rotary Engine Building, Porting & Swaps
1
05-09-2008 07:58 PM
TheRonin
RX-7 & RX-8 Parts For Sale & Wanted
0
11-20-2007 07:44 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)