here are some of the small problems i have... and a pic of my sweet seats , and my modded gas cap

 

EGADS!!!!!



Edward-metal-scissorshand has been a hackin on yer tunnel matey!





Want me to cut the tunnel opening out of an RX-7 to weld/bond in place?

 

nice fuel pump bracket too!

 

looks like a "native" hawain taxi driver wired it up!



Where is that damn pic when I need it!!!!

 

lmao

 

http://www.lizardskin.com/

 

that would be terriffic. im gonna be modding the tail end ofmy t2 so it fits in the factory position.

 

i didnt REALLY want to go with a spray on type, but how does that hold up if i was going to be welding on it, like installing a roll cage?

 

Eric, the base metal would have to be properly prepped for welding by grinding to bare clean shiney metal. After your re-enforcing plates and cage are welded in; then you could do a local re-application of the spray on product

 

i figured that, but how does it respond with all that heat close to it? would i have to take ALL of it off, or just around where ill be welding?