Northwest Anything that pertains to Northwest owners.

Hot Coil?

Thread Tools
 
Search this Thread
 
Old Mar 21, 2007 | 09:04 PM
  #1  
Kill No Cone's Avatar
Thread Starter
Senior Member
 
Joined: Jan 2003
Posts: 207
From: Olympia WA
Default

Ok, had a great day of racing on Sunday. On the way home, just as I think to myself "my car worked flawlessly," then it died. If I let it sit for a minute or two it will run for about 15 minutes, then it dies again...damn.



I think it my be the coil. I have just gone with a direct fire system with an MSD powering a stock 2nd gen coil. The coil has been taken off the alum mount (and stripped of the igniter) and mounted on the inner fender well. Looks very clean, but I am thinking that it just does not have enough of a heat sink with all the power from the MSD.



So, what do you think?
Old Mar 21, 2007 | 10:00 PM
  #2  
woundup7's Avatar
Senior Member
 
Joined: Jan 2006
Posts: 545
Default

Sounds like a fuel issue, dirty filter, dirty pickup, as you drive along the crap is making its way to the filter, plugs the filter. Car dies, fuel pressure goes down crap returns to the bottom. Then is sucked back up to the filter. Dont laugh, I have had this happen on my 1973 VW fastback with a 32/36 weber carb. the tiny little screen on the carb inlet was a sand trap. I have a few extra leading coils with the ignitor still attached if you want to swap them around.



Seriously dont think its the coils JEB. I have been running that setup for two years exactly. Except I just switched it back over to two blaster coils instead of the FC leading coil pack. I think the heat sinks are really just for the ignitors, which you dont have any more. FD coils dont have heat sinks, because the ignitor is a seperate item. Hope that helps.
Old Mar 21, 2007 | 10:29 PM
  #3  
bstrange99's Avatar
Senior Member
 
Joined: Jul 2004
Posts: 376
From: Spokane
Default

Have you cranked the motor with a timing light connected to the coil wires? It wont show any spark if the coils are open. Is it all 2nd gen direct fire, or just the leading? Possibly the trailing ignitor?



I would tend to agree with Chris on the fuel issue. Change the filter, check for flow at the carb, yadda yadda yadda, you know the routine.

Good luck
Old Mar 22, 2007 | 12:12 AM
  #4  
woundup7's Avatar
Senior Member
 
Joined: Jan 2006
Posts: 545
Default

JEB is not running any trailing ignition on this motor. Just leading through the MSD "finally" to a FC leading coil pack. Correct me if I am wrong JEB. but I believe that is his setup.
Old Mar 22, 2007 | 12:24 AM
  #5  
Kill No Cone's Avatar
Thread Starter
Senior Member
 
Joined: Jan 2003
Posts: 207
From: Olympia WA
Default

Yup, that is the setup...

Ok, a couple times when I got in the car I thought that the fuel pump was sounding differntly. Then said it just must be that I have not driven since last summer and it sounds louder.



I will look at the fuel first?



I had thought of putting a timing light on to see if I was getting spark but the problem comes and goes so quickly.
Old Mar 22, 2007 | 12:49 AM
  #6  
Hyper4mance2k's Avatar
Senior Member
 
Joined: Jul 2002
Posts: 875
From: DC
Default

if it's your fuel pump you'll notice that it's spinning faster, not louder. Get rid of the 2nd gen coil and get a MSD DIS coil they're only $40. Jeff noticed the FC coils were getting really hot just bench testing them with the MSD.
Old Mar 22, 2007 | 04:08 PM
  #7  
rmriggin's Avatar
Senior Member
 
Joined: Feb 2005
Posts: 519
Default

FC coils do get hot. I remember that from when I ran direct fire on my first gen. The heat sinks are mainly for the igniter but they help the coil a little bit also.
Old Mar 22, 2007 | 09:57 PM
  #8  
Kill No Cone's Avatar
Thread Starter
Senior Member
 
Joined: Jan 2003
Posts: 207
From: Olympia WA
Default

Not sure

I will swap out the fuel filter and run the car. If it dies again I will check the coil.
Old Mar 22, 2007 | 10:29 PM
  #9  
woundup7's Avatar
Senior Member
 
Joined: Jan 2006
Posts: 545
Default

Does the carb inlet have a screen behind the banjo bolt, be sure to check that as well.
Old Mar 22, 2007 | 10:39 PM
  #10  
Kill No Cone's Avatar
Thread Starter
Senior Member
 
Joined: Jan 2003
Posts: 207
From: Olympia WA
Default

Will do, thanks!
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Tomoya
2nd Generation Specific
8
May 23, 2006 04:54 PM
Syonyk
2nd Generation Specific
19
Jun 9, 2004 10:28 PM
MrSparkle
2nd Generation Specific
7
Jan 3, 2004 02:24 PM
j9fd3s
Insert BS here
33
Jun 26, 2003 02:14 PM
fritzfry
3rd Generation Specific
13
May 20, 2003 12:42 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 



All times are GMT -5. The time now is 03:31 PM.