#3
|
To clear things up for the above fellow, someone figure out the gauge piping or the wall thickness of the tubing on the Obx unit. There is a reason there are no copyrights to exhaust manifolds, there just isn't that many ways to do it...
|
As you can see the Flange is very thick, I serisously doubt the OBX unit is anywhere near close.
|
...
|
Originally Posted by setzep' date='Feb 8 2005, 08:06 PM
Have you guys ran one of these manifolds on a car yet to test it out? I ask because sometimes bracing is the cause of a manifold cracking apart. When the tubing expands faster than the brace you'll get a crack where the brace is attached to the tubing.
BTW, you're a lucky SOB to work in a shop like that... These have already been ran on serveral 3rd generation Rx-7s. Yes Dave I am now in Arizona, these units are made in the family owned Exotic shop. They were actually made a long time ago, I believe over a year. They just never surface until I came down. |
Here is the manifold I was sent by Davinchi. I think it's OBX/SSauotchrome.
https://www.nopistons.com/forums/upl...1087406574.jpg |
lighting didn't turn out as I had planned, the coating is actually a more goldish color.
|
Originally Posted by 1Revvin7' date='Feb 8 2005, 08:06 PM
These have already been ran on serveral 3rd generation Rx-7s.
Yes Dave I am now in Arizona, these units are made in the family owned Exotic shop. They were actually made a long time ago, I believe over a year. They just never surface until I came down. Your family owns an exotic shop? You bitch. I thought my great uncles Harley shop was the **** but we don't have any pimp ass exotics laying around. https://www.nopistons.com/forums/pub...1047683664.gif |
Dave can you take a picture of the 1st Large picture I posted on this page entitle " closeups". It appears that your Davinci unit uses much smaller diameter main runners.
|
Well they do look some what wider. Best way to tell for sure would be to wrap an seamstress tape around it for a proper measurement. However it's pretty obvious that the two are totally different. The one you posted inages of has a three piece pipe and the Davinchi is one piece. Look at the welds and one can easily see the difference. I would like to buy one as well but as Martin mentions the down pipe most likely will not fit. Chances of the turbo being in the same spot is pretty f-ng slim. Too bad to because the manifold looks pretty sweet. https://www.nopistons.com/forums/pub...1047683894.gif
|
All times are GMT -5. The time now is 02:51 PM. |
© 2024 MH Sub I, LLC dba Internet Brands