RX-8 Discussion Discussion on Mazda's newest rotary powered vehicle.

finally back and running right

Old Jan 18, 2007 | 01:13 PM
  #1  
Sivart_R1's Avatar
Thread Starter
Senior Member
 
Joined: Jan 2003
Posts: 148
From: Washington
Default

Some of you may remember my post about the cracked intake manifold that was fixed at the same time as the latest emissions recall was done. When we got in the car after all that was finished, the check engine light was on again. We drove home that night (had been at the dealership far too long to wait around any longer) and dropped it back off the next morning, turns out the 02 sensors had intermittant faults. Since the dealership had to oder the sensors, it was another week and a half of driving around with the CEL on, meaning limp home mode.



As of Tuesday evening, the O2 sensors have been replaced, the CEL is off, and the car seems to be running right finally. Not sure if it's because of the limp home mode for so long, but after the emissions flash, the car seems to run much better in the low end of the rev range, and definately idles smoother now.



Hopefully the last of the snow and slush melt off soon, and I can see how the car feels under more "spirited" driving...



Oh, and for the record...a good set of snow tires makes even a non-TCS equipped 6 speed RX-8 into a snowmobile.
Old Jan 19, 2007 | 09:42 AM
  #2  
j9fd3s's Avatar
Senior Member
 
Joined: May 2002
Posts: 22,465
From: California
Default

not sure why, but the new plugs make a huge difference, plus you've got a nice clean intake manifold too!
Old Jan 22, 2007 | 07:11 AM
  #3  
TrackJunkie's Avatar
Junior Member
 
Joined: Oct 2006
Posts: 25
Default

new plugs make a huge difference. I am on my third set, at almost 60K miles. Most of our local group replace theirs after about 20K miles, less if there was a lot of track time on them. Wires seem to not hold up for too long either. Glad you got the car running again, I know how much it sucks to be without it for a while.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
bstrange99
Northwest
11
Apr 1, 2007 06:52 PM
rmaiersg
2nd Generation Specific
7
Apr 16, 2003 05:43 PM
phinsup
Insert BS here
8
Aug 16, 2002 11:12 AM
phinsup
Front Desk
0
Mar 21, 2002 09:08 AM
vosko
3rd Generation Specific
40
Jan 28, 2002 01:41 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Thread Tools
Search this Thread

All times are GMT -5. The time now is 10:59 PM.