Genuine Racing Beat Dellorto 48 DHLA intake system, MANY NEW PARTS

Reply Subscribe

Thread Tools

Search this Thread

01-08-2008, 12:59 AM

12aJBridgeport

Member

Thread Starter

Join Date: Mar 2004

Posts: 37

This intake has been my pride and joy for the last 4.5 years and now it's time to let it go. Very well maintained, rebuilt twice since I've owned it! Cleaned on a regular basis. I've run a lot of Seafoam, Amsoil PI, Gumout Fuel Injection Cleaner in the gas tank since I've owned this carb so you know it's clean internally. Tuned with wideband O2 sensor, this puppy runs sweet. Fantastic low to midrange and the top end does not dissapoint.

Many upgrades and new parts. You won't find a nicer Dellorto anywhere! This carb will last a very long time.

All cleaned up and ready to install. Look how shiny all that aluminum is!!!

Rebuilt recently, all new gaskets, o rings, and Accelerator pump diaphragm

New thick accelerator pump gasket, just like Racing Beat. NLA!!!

New carb Lid. aka Top Cover. Not cheap. The choke operated a lot better after the new lid was installed, and overall the carb just ran smoother!!!

Manifold is for the Old School 13b 4-port.

New floats

New, proper sized 3.00mm needle and seat. These are no longer available anywhere!

New plastic jet cover and gasket

New anti-vibration soft mounts and nylox nuts

New idle mixture screws, washers, o-rings, and springs

New progression hole threaded plugs

New accelerator pump rod assembly

New screws for carb Lid.

4" long TWM Induction bellmouth velocity stacks. State of the art. Flow more air than any other stack. Really helps low and mid range torque

New nylox nuts and washers for stacks.

6" long K&N air filter, great shape low mileage

Authentic Racing Beat air filter plates

39mm chokes installed, and 40mm chokes included

Many Spare jets.

Authentic Racing Beat two piece intake manifold

New bolts to attach the 2 piece manifold

Gasket inbetween 2 piece manifold replaced in 2004

The air filter is very long to fit the stacks, and allow the most air to flow in. And requires you either bend or cut/reweld the oil filler tube or just plug it with the included red plastic plug.

.

.

.

.

.

.

$699.00 + shipping Local Los Angeles pickup can be arranged. Ready to sell. Serious buyers only. Lowballers don't waste my time or yours. It would cost you > $1100 to piece this together and still many parts are No longer available (all RB specific parts and 3.00 n/s) !!!!

Contact me by sending PM or email from my profile.