mako

Making some major changes to my car so I have a lot of stuff I need

to sell.



HKS single turbo kit.



kit includes.

HKS stainless manifold no cracks.

HKS GT 60mm wastegate used 7 monhts. 8psi spring

HKS T45s turbocharger. same wheels size as T04r on the compressor side. .72 ar compressor housing.

Q trim exhaust wheel in a .90 hks a/r exhaust housing. turbo has very little lag for its size.

I can get full boost between 3500-3800 rpm. the turbine wheel has a few small chips from the previous owner.



I have ran the turbo this way for the past year with no issues. there is a small amount of shaft play but it does

not seem to have any effect on it. my car dynoed 297 to the wheels on 8psi of boost. very conservite tuning and timing.

the turbo is probably not even in its effciency range till around 15 + so a little more boost should yeild a lot higher #'s

custom made 3 inch downpipe with egt hole, o2 sensor at bottom of downpipe for wideband. the wastegate is routed back into

the downpipe so its not so loud. open wastegate gets annoying after a while for a daily driven car.

comes with rear block off plate for turbo drain, and modified stock front turbo drain. comes with all oil feed

line, and return line a new hks exhaust gasket from turbo to downpipe.

comes with a Jspec lower intake manifold that is needed for the kit. makes it so you dont have to modify your existing

lower intake manifold where the egr is.



I am pretty much including everything you need to bolt on the kit and go, you will need to make a new outlet pipe from the

the turbo outlet to match your intercooler setup. unless you buy the intercooler setup I am selling. I will include that stuff.

looking for $2000 for everything.

or $2400 with the turbo rebuilt by majestic here in dallas.



also for sale:



older model Greddy 3 row front mount intercooler in excellent condition. this intercooler is not as wide as the new

model greddy. while it does not look as bling bling, it does not totally block all air to the radiator. I have not had any cooling issues over the past year in

texas summer with this setup. this unit works great. shows about 10 degree F over ambient outside temps. Many top racers still use this unit.

used for about a year. no bent fins or chips anywhere.

comes with the outlet pipe going to the greddy elbow. it has a hks falnge welded on for the racing or super sequential

blow off valve. I would like to sell the intercooler with the blow off valve. and you will need a greddy elbow to make it work.



Inetercooler comes with all mounting hardware. the power steering line, insturctions, brackets to move radiator. pretty much

complete bolt on kit like you would get from the factory.





intercooler with outlet pipe, and hks super sequential bov. $950

intercooler with outlet pipe but no bov. $800

Greddy polished elbow $100



koyo polished radiator, about a year old excellent condition, worked great. $300



Nology spark plug wires excellent condition $75



Mild steel midpipe bonez? i think.. has surface rust but will last forever.. $100



Supra TT fuel pump used for 1 year works great. $150



Marvelspeed polished secondary fuel rail with 1680cc injectors about a year old. excellent fuel upgrade. $300



Paxton Fuel pressure regulator 1 to 1 rate boost sensitve regulator. has -10 an inlets, -6 or 8 return line

1/8 npt pressure port, 1/8 port for fuel pressure gauge. excellent condition. $125 comes with some fittings.



93 gauge cluster hood decent shape with some scratches and good for a project or be refinished. $45



93 center console where the shifter/ash tray is. some peeling and scratches good for project or refinish. $45





Feed shift **** used for about 3 months. fits stock 93 up threads pretty heavy weighted ****. has a type of rubber/nylon

top part and alum bottom part. $90

Feed oil cap used for about a year still looks new. $60

Feed T-shirt white, says fujita engineering on front and FEED race team on the back. never worn new. xl size but fits like a large. $35







I think thats about it for now untill I figure out what else.

I have pics up at pics are here!



I will put more pics of stuff later tonight.

email me with any questions. most prices are pretty firm but you can make offers.

payments terms.

I am paypal verified. if you want to use paypal i wil take a small hit but buyer has to pay 1.5%

I can also do moneyorder certified check or will do COD at the buyers expense. Buyer pays shipping. if its an expesive item

we can try and work out the shipping.



I have over 120 positive feedback on ebay, people in the south forum can be used as refrences. I am active in the dfwclub, and

people see my car running every week.



I can take more pics, video or whatever the buyer needs.

email mako@nationwide.net for questions ect.



reasons for selling, since people want to know.. Need to pay off debt and I want to go back to college..

this setup works awesome for a daily driven car and has not given me any problems over the past year.



all parts are still on my car in good working order. so it will take me a day or so to removed box and have stuff ready to ship.

thanks,

James

rfreeman27

have you sold the FMIC?