Hi,



I have attached here photos of rotor housings that I have. These housings do not have any scratches on them the only issue is the slight mark on the edge which is very small on one housing. I think these have been marked in storage. I have attached photos of both. Please advise Can anyone of these be used?



Thanks guys...

 

there is a mazda spec for a wear groove at the edges that is allowable for rebuild,,

yours has is but a minute snick,,, and its not in the compression,, but the expansion area of the housing



AOK --for reuse ,, mazda groove spec is far worse

 

Bumpstart Thanks for the informative reply... It is much appreciated...