Teflon Coolant O-rings?
Senior Member
Joined: Jun 2003
Posts: 208
From: San Antonio TX/Okinawa Japan
http://groups.msn.com/ChucksRX7/1983rx7.ms...hoto&PhotoID=94
I ordered the outer coolant seals from them but did not like how they fit. Lot bigger then stock. Dont remember the stock # for the outer.
chuck
I ordered the outer coolant seals from them but did not like how they fit. Lot bigger then stock. Dont remember the stock # for the outer.
chuck
Thread Starter
Senior Member
Joined: Oct 2001
Posts: 1,675
From: Clifton, NJ
If they are too big, they can get pinched when the motor is assembled and leak. I need to find the right size. My main concern the inner o-ring, as I have seen some come out of brand new sealed gasket kits dry and brittle.
to infinity & beyond, me
Joined: Aug 2001
Posts: 5,124
From: santurce
i got the mcmaster catalog in front of me. they have these seals"kalrez perfluoroelastomer" o rings. they sound pretty good.(maybe for the oil control rings)
as soon as i know part numbers or sizes ill ask how much i can get them here at work. maybe cheaper, maybe not. maybe i can have my job pick up the tab...
as soon as i know part numbers or sizes ill ask how much i can get them here at work. maybe cheaper, maybe not. maybe i can have my job pick up the tab...
Senior Member
Joined: Feb 2003
Posts: 223
From: Corvallis, Oregon
I ordered some of these a few months back for my rebuild and they fit perfectly and have been trouble free over the past 2000 miles. I have the part number at home and will post it in a day or so if anyone still wants it then. They were $45 including shipping for 4.
Senior Member
Joined: Jun 2003
Posts: 208
From: San Antonio TX/Okinawa Japan
The McMaster-Carr stock # is AS568A dash # 175 for the inner coolant seals. The link I posted earlier shows this seal and stock number. Posted a pic to make sure we were talking about the same seals. The inner seals worked good in my opinion. Pic shows the seal on a 12A rotor housing but I also fit them to a 87 13B end plate, fit was good.
The stock number for the outer seals that were posted on the net were to big in my opinion. I felt it would put to much stress on the outer edge of the coolant seal groove.
chuck
The stock number for the outer seals that were posted on the net were to big in my opinion. I felt it would put to much stress on the outer edge of the coolant seal groove.
chuck
