smoking after rebuilt..
#1
Hello guys,
This is my 2nd rebuilt (non turbo) and the engine since to be running good (130 miles after rebuilt). I only notice the engine still smoking a littler at idle, when I am driving is hard to see smoke. The second problem is the RPM is not stable AT idle. I did the TB mod and all emissions is gone. The BAC valve still in place.
Normally for how long the rebuilt engines smokes ? Normally the idle is unstable during the break-in period. I been looking for VAC leak but I don't find any...
Thanks for the help guys ...
This is my 2nd rebuilt (non turbo) and the engine since to be running good (130 miles after rebuilt). I only notice the engine still smoking a littler at idle, when I am driving is hard to see smoke. The second problem is the RPM is not stable AT idle. I did the TB mod and all emissions is gone. The BAC valve still in place.
Normally for how long the rebuilt engines smokes ? Normally the idle is unstable during the break-in period. I been looking for VAC leak but I don't find any...
Thanks for the help guys ...
#2
Originally Posted by rotativo08' post='823589' date='Jun 12 2006, 08:05 AM
Hello guys,
This is my 2nd rebuilt (non turbo) and the engine since to be running good (130 miles after rebuilt). I only notice the engine still smoking a littler at idle, when I am driving is hard to see smoke. The second problem is the RPM is not stable AT idle. I did the TB mod and all emissions is gone. The BAC valve still in place.
Normally for how long the rebuilt engines smokes ? Normally the idle is unstable during the break-in period. I been looking for VAC leak but I don't find any...
Thanks for the help guys ...
What did you replace in the rebuild? i might still be running in
#3
Originally Posted by loudnproud' post='823617' date='Jun 11 2006, 03:11 PM
What did you replace in the rebuild? i might still be running in
I replaced apex seals, side seals, cornel seal, all the springs and new rotor and stationary gear bearings. Rotors and housings was in reusable condition. Also the sides plates was resurface. This engine was running good before the rebuild, the only problem was oil leak.
Thanks again for the help...
#4
The idle will surge some until the seals seat in better. it will take a little time. some as little as 5-600 miles some 1000 or more. There is no definite. Alot depends on how worn the housings were.
On the smoking did you replace the oil scrapers and springs?
On the smoking did you replace the oil scrapers and springs?
#5
Originally Posted by rotaryinspired' post='823656' date='Jun 11 2006, 08:27 PM
The idle will surge some until the seals seat in better. it will take a little time. some as little as 5-600 miles some 1000 or more. There is no definite. Alot depends on how worn the housings were.
On the smoking did you replace the oil scrapers and springs?
Thanks for the help rotaryinspired....
The oil scrapers is the side seals? If it that, the seals and springs are new. The engine is running good except for smoking a little at idle, If everything is ok under a normal overhauling, please a simple answer on miles or hours, for how long the smoke blue... I like to know if it is normal...
Thanks again guys ..
Thread
Thread Starter
Forum
Replies
Last Post
showoff247
3rd Generation Specific
1
06-26-2006 11:19 PM
BlownSE
1st Generation Specific
11
03-20-2005 09:43 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)