Side Seal
#3
i dont think you under stand wot i mean,yes i know how to cut a side seal and get a good result but wot does the factory use to make all these engines accuratlly and or other peoples design
#5
At the factory, mazda has a special machine set-up to cut side seals, they cut them to various pre-sized lengths in order to allow the rotor-stuffer to do selective fit of the various seals.
Rob at Pineapple Racing is supposedly prototyping a seal fitting fiture to sell to the public. Call him for the status.
Rob at Pineapple Racing is supposedly prototyping a seal fitting fiture to sell to the public. Call him for the status.
#8
I'd like to rig something up with an old rotor and a sanding drum in the corner seal hole. I used the sanding drum on the dremel last time and that worked okay but it's a bit difficult to guide the side seal by hand.
Thread
Thread Starter
Forum
Replies
Last Post
John V
Rotary Engine Building, Porting & Swaps
3
04-03-2010 05:51 PM
-xlr8planet-
Rotary Engine Building, Porting & Swaps
5
12-28-2008 11:51 AM
White_FC
Rotary Engine Building, Porting & Swaps
4
03-11-2004 10:45 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)