Opinions on my P.port housings
#51
well i just cranked some out so check em out and tell me what you guys think.
they are different heights because i was just testing what the hole saw could and could not cut. as you could see that last one ran out of cut right at the very end and would not go all the way though.
i dont have sleeves in any of them because the tube/pipe is 23 bucks a ft and im to poor to keep buying that but.
i did do one just to see how it would fit. worked great! im soon going to be making some with more angled ports like on the RB ones. then im going to run one set while my friend 2A-ron is going to run the other set. then we can get some dyno charts for comparison so you guys can check em out. the best part is how fast i can make these things. YAY for testing!
they are different heights because i was just testing what the hole saw could and could not cut. as you could see that last one ran out of cut right at the very end and would not go all the way though.
i dont have sleeves in any of them because the tube/pipe is 23 bucks a ft and im to poor to keep buying that but.
i did do one just to see how it would fit. worked great! im soon going to be making some with more angled ports like on the RB ones. then im going to run one set while my friend 2A-ron is going to run the other set. then we can get some dyno charts for comparison so you guys can check em out. the best part is how fast i can make these things. YAY for testing!
#52
interestingly enough i found the highest and lowest points you can really go with the hole saw method. or at least the straight in hole saw method. interesting fact, there is only about .2" of up and down you can get using the hole saw. and i ran into tons of problems while making these and got pretty freaked at first. so if you start making these and also run into issues dont worry about it, its just that every other post i have read about making these seemed so easy and it is once you have done it a couple of times but those first few take some getting used to.
Thread
Thread Starter
Forum
Replies
Last Post
TweakGames
Rotary Engine Building, Porting & Swaps
25
10-14-2007 12:10 AM
ufc_fan1
Rotary Engine Building, Porting & Swaps
1
05-03-2006 02:00 PM
ReactionEffect
Rotary Engine Building, Porting & Swaps
10
09-28-2005 03:26 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)