New Motor time
#1
Finally geting around to building a new Motor for this beast.
Project Zuki is getting a new motor.
I like the N/A 6 ports so I am keeping them. They sound a bit like a bridgeported motor.
Go here for video/audio (Note this is BEFORE the reuild).
6 Port end plates (They offer addition intake timing)
Turbo II Center Plate
Turbo II Housings
Turbo II Rotors
20 lbs Flywheel
Turbo II Transmission
in a Suzuki Sidekick!
Stock 6 Port w/ Porting Template (RED)
Stock N/A Motor center plate w/ Porting Template (RED)
Same Template on a Turbo II center plate (RED)
Project Zuki-R
Project Zuki is getting a new motor.
I like the N/A 6 ports so I am keeping them. They sound a bit like a bridgeported motor.
Go here for video/audio (Note this is BEFORE the reuild).
6 Port end plates (They offer addition intake timing)
Turbo II Center Plate
Turbo II Housings
Turbo II Rotors
20 lbs Flywheel
Turbo II Transmission
in a Suzuki Sidekick!
Stock 6 Port w/ Porting Template (RED)
Stock N/A Motor center plate w/ Porting Template (RED)
Same Template on a Turbo II center plate (RED)
Project Zuki-R
#3
Originally Posted by dac' post='868167' date='Apr 14 2007, 07:06 PM
Finally geting around to building a new Motor for this beast.
Project Zuki is getting a new motor.
I like the N/A 6 ports so I am keeping them. They sound a bit like a bridgeported motor.
Go here for video/audio (Note this is BEFORE the reuild).
6 Port end plates (They offer addition intake timing)
Turbo II Center Plate
Turbo II Housings
Turbo II Rotors
20 lbs Flywheel
Turbo II Transmission
in a Suzuki Sidekick!
Stock 6 Port w/ Porting Template (RED)
Stock N/A Motor center plate w/ Porting Template (RED)
Same Template on a Turbo II center plate (RED)
Project Zuki-R
Okay so I did all of my plates today. I was a little suprised at how easy it was. I'd heard all the horror stories about going through various bits, and the need of carbide stones etc.
I had a set of stones I picked up as a set (cheap) I used 2 of them and the job is done.
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)