Mt Race Corner Seal Springs In Bp N/a
#1
would using race corner seal springs make it any more likely for the corner seal to fall in when using a 4mm bridge? the reason i ask is because i dont trust them little flimsy ones and the corer seal is only out about .015
#4
Originally Posted by FrostRacing' date='Feb 4 2004, 02:48 PM
would using race corner seal springs make it any more likely for the corner seal to fall in when using a 4mm bridge? the reason i ask is because i dont trust them little flimsy ones and the corer seal is only out about .015
With a bridge that narrow, a three piece apex seal is out of the question.
So long as any part of the corner seal is supported by the bridge, it can't fall out.
The bridge should also support the leading end of the side seal, and that would put the corner seal almost dead center on the bridge.
Lynn E. Hanover
Thread
Thread Starter
Forum
Replies
Last Post
-xlr8planet-
Rotary Engine Building, Porting & Swaps
5
12-28-2008 11:51 AM
White_FC
Rotary Engine Building, Porting & Swaps
4
03-11-2004 10:45 PM
SPOautos
Rotary Engine Building, Porting & Swaps
9
02-19-2004 09:42 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)