Intakes
#1
does anyone have any experience extrude honing thier intakes? the castings are rough inside i was wondering if anyone had a personal experience with it. it does help n/a piston cars a good bit but i have not heard of any rotary applications.
#4
"Too expensive for the gains in my opinion. I'm in the process of sandblasting smooth the inside of mine. I purchased a sandblaster from harbor freight for $70!"
How are you doing that??
Are you using large very abrasive media for long periods of time?
and adjusting the sprayer periodically
to add to the original question..
anyone concerns about the secondary injector ports when extrude honing...
curious as to whether or not there my be injector fitment issues after..
anyone concerns about the secondary injector ports when extrude honing...
curious as to whether or not there my be injector fitment issues after..
Why would there be unless they purposely ran the media through the port?
Thread
Thread Starter
Forum
Replies
Last Post
mazdaspeed101
2nd Generation Specific
25
11-09-2002 10:10 PM
OKIERX-7
2nd Generation Specific
29
09-15-2002 05:28 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)