so i have heard of people having the rotor housings refinised. i talking about the acctual combustion wall were the apex seal rides. i have a good housing with a scrape along the edge were the corner seal failed. i have now purcased two different housing only to receive crap parts. the last one i got was awful i dont' even know how you could melt a housing but this one was melted. so basically im wondering if anyone has had this done with success and who did the work. also how good do the housings need to be? i have heard of people using them if there alittle scaped up after a apex seal failer.

 

If the damage is bad enough, the cost to fix it will not be worth it.

 

Take a look at these folks. J.H.B. Performance - Cermet-Coated Rotary Engine Components



Lynn E. Hanover

 

i checked them out there very nice people. but its about 300 to fix the housing. i can pretty much get a good used one for that. but if you want to ceramic coat that stuff there the dudes to see