Half Bridge Project (opinions Needed)
#1
I need some opinions on this
http://www.1131.net/pics/dan/DSCN1235.JPG
good enough?
how do you prevent going to deep on the upper side of the street port, i went ahead and played with porting this and i got too deep and into the water jacket
any suggestions?
http://www.1131.net/pics/dan/DSCN1235.JPG
good enough?
how do you prevent going to deep on the upper side of the street port, i went ahead and played with porting this and i got too deep and into the water jacket
any suggestions?
#6
it's just that the pressure from the charged air and the pressure from the warm coolant, heat cycles, etc, i don't know if i can trust that method
i want to hear people chime in who have done this and have had no problems
i want to hear people chime in who have done this and have had no problems
Thread
Thread Starter
Forum
Replies
Last Post
walter
Rotary Engine Building, Porting & Swaps
0
10-12-2003 07:13 PM
cpracing
RX-7 & RX-8 Parts For Sale & Wanted
0
07-12-2003 09:47 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)