Just got it in and on ....kinda.

Holes didnt match up on some. Any body else have this? I guess I can drill out the difference.

 

i *heard* you put it on upside down

 

haaahaha. i have one.... but never installed it. I can check tommorrow to see if it lines up with one of my old oilpans.

 

[quote name='vosko' date='Apr 24 2005, 10:30 PM']i *heard* you put it on upside down


[/quote]

it only goes one way damn you.

 

[quote name='l8t apex' date='Apr 25 2005, 01:10 AM']it only goes one way damn you.


[/quote]



upside down? haha

 

which holes don't line up?

 

I had the same problem. I enlarged the hole two drill bit sizes, sorry I do not remember what size I ended up with. Its a real PITA to install if not lined up properly, there is a wave in my brace and I ended up snapping a one of the bolts. I then got the Moroso stud kit and installed it.



Then after it was done torquing I forgot to put the engine mount bolts in.... I hope that will not cause a problem I am sure/hope the pressure from the brace made it nice and snug.

 

two on the turbo side...center (iron) section and the next one to it on front rotor housing. Drilled towards pan and forward. Then in front lip two holes . Expanded those also based on others that were correct.