ceramics
#1
how do people use ceramics in rotary engines? particularly coatings. im sure they can be used on the rotor faces, maybe the side of the rotors, and definitely in the ports, but more than that i dont know.
and another question, isnt the rotary engine a very good choice for ceramics in the rotor core materials and intermediate plates? since a rotary engine doesnt jerk around like a piston engine, ceramics should work very well.
and another question, isnt the rotary engine a very good choice for ceramics in the rotor core materials and intermediate plates? since a rotary engine doesnt jerk around like a piston engine, ceramics should work very well.
#3
ceramic coatings are sometimes used. however quite cost ly and mostly only necessary in "competition" engines
Rotorsports racing does some coating www.rotorsportsracing.com
if you wanna spend big $$$ contact
JHB Performance www.jhbperformance.com (In canada) they can coat your engine with the same special coatings as in the 787b
Rotorsports racing does some coating www.rotorsportsracing.com
if you wanna spend big $$$ contact
JHB Performance www.jhbperformance.com (In canada) they can coat your engine with the same special coatings as in the 787b
#6
Originally Posted by 1Revvin7' post='848849' date='Dec 12 2006, 10:54 AM
There are a lot of benefits for ceramics on street cars.
Everything is coated on the engine below( rotor housings/side plates, rotors bearing, pump etc)
how well did that work? any improvement when it runs? less misfires, more HP? what type of coatings did they use(oil shedding, friction reduction, heat reflective)? and where did they use them?
#7
Originally Posted by Niven' post='849036' date='Dec 13 2006, 06:40 PM
how well did that work? any improvement when it runs? less misfires, more HP? what type of coatings did they use(oil shedding, friction reduction, heat reflective)? and where did they use them?
From my personal experience, other REAL racers, engine builders etc they work extremely well.
Owner of one race team reported a 40deg DROP in oil temp. He runs a Gt47 @ 45psi on his drag Rx8.
However hard numbers are coming soon.
#8
Originally Posted by 1Revvin7' post='848849' date='Dec 12 2006, 09:54 AM
There are a lot of benefits for ceramics on street cars.
Everything is coated on the engine below( rotor housings/side plates, rotors bearing, pump etc)
Where did you get this done? At one of the places mentioned above?
#9
there has been alot of problems latly with the place above i would look for another or make sure u are located close to them they are in canada and have had numerous problem shipping other forum members stuff back to them
#10
Originally Posted by REZCAR' post='852194' date='Jan 8 2007, 01:50 AM
Where did you get this done? At one of the places mentioned above?
We are the ones doing those pictured.
Jwteknix I believe is referring to JHB.