Apex seal still useable?
#1
Starting to put a plan together to rebuild my 12A race after I lost the front stat gear (see post in engine failure section).
One of my ceramic apex seals took a little damage in the incident.
What do you guys think, will this seal still work? Will I see much affect in compression from these minor chips?
On one end, there is a tiny chip up by the corner edge that sweeps along the rotor housing.
On the other end there are two chips further down the seal where the corner seal cradles the seal.
Any concern that the seal has further damage (fractures) and will come apart during use?
Thanks,
Neil
One of my ceramic apex seals took a little damage in the incident.
What do you guys think, will this seal still work? Will I see much affect in compression from these minor chips?
On one end, there is a tiny chip up by the corner edge that sweeps along the rotor housing.
On the other end there are two chips further down the seal where the corner seal cradles the seal.
Any concern that the seal has further damage (fractures) and will come apart during use?
Thanks,
Neil
#2
Originally Posted by sevenracer' post='920659' date='Apr 18 2009, 09:02 AM
Starting to put a plan together to rebuild my 12A race after I lost the front stat gear (see post in engine failure section).
One of my ceramic apex seals took a little damage in the incident.
What do you guys think, will this seal still work? Will I see much affect in compression from these minor chips?
On one end, there is a tiny chip up by the corner edge that sweeps along the rotor housing.
On the other end there are two chips further down the seal where the corner seal cradles the seal.
Any concern that the seal has further damage (fractures) and will come apart during use?
Thanks,
Neil
One of my ceramic apex seals took a little damage in the incident.
What do you guys think, will this seal still work? Will I see much affect in compression from these minor chips?
On one end, there is a tiny chip up by the corner edge that sweeps along the rotor housing.
On the other end there are two chips further down the seal where the corner seal cradles the seal.
Any concern that the seal has further damage (fractures) and will come apart during use?
Thanks,
Neil
The seal is fine.
Lynn E. Hanover
#4
Not 100% sure - I got them used, but I think they are an older set of Ianetti single piece seals. He only makes 2 piece seals now.
By the way, the engine is back together and running quite well on track. Still a bitch to start when hot.
-Neil
By the way, the engine is back together and running quite well on track. Still a bitch to start when hot.
-Neil
Thread
Thread Starter
Forum
Replies
Last Post
John V
Rotary Engine Building, Porting & Swaps
3
04-03-2010 05:51 PM
rx7man629
RX-7 & RX-8 Parts For Sale & Wanted
0
04-09-2007 09:13 PM
1Revvin7
Rotary Engine Building, Porting & Swaps
12
10-12-2003 02:38 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)