13B RE Front Pulley Bolt
07-30-2007, 01:46 AM
#1
Senior Member
Thread Starter
Join Date: Nov 2001
Location: LA, USA
Posts: 1,622
What is the correct torque spec for the front pulley bolt for the 13B cosmo?
Since the engine is a hybrid between the FC and FD it could go both ways.
Since it took over 300lb of force to get off, I torque the bolt back down to 180ft/pounds just like the FD motor.
Is over torquing this bolt bad? I didn't remember to check the end float just to check.
The engine is in the car but it should be too bad to check again.
C
Since the engine is a hybrid between the FC and FD it could go both ways.
Since it took over 300lb of force to get off, I torque the bolt back down to 180ft/pounds just like the FD motor.
Is over torquing this bolt bad? I didn't remember to check the end float just to check.
The engine is in the car but it should be too bad to check again.
C
07-30-2007, 12:30 PM
#3
Senior Member
Thread Starter
Join Date: Nov 2001
Location: LA, USA
Posts: 1,622
Originally Posted by BDC' post='878973' date='Jul 30 2007, 09:56 AM
Wouldn't worry about it.
B
B
Thanks Brian.
There is nothing like working on 2 projects at the same time and keeping it straight.
Thread
Thread Starter
Forum
Replies
Last Post
FikseRxSeven
3rd Generation Specific
7
01-23-2006 09:16 PM
FikseRxSeven
RX-7 & RX-8 Parts For Sale & Wanted
6
10-14-2005 02:26 PM
banzaitoyota
Rotary Engine Building, Porting & Swaps
1
01-15-2005 11:07 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)