What is the correct torque spec for the front pulley bolt for the 13B cosmo?



Since the engine is a hybrid between the FC and FD it could go both ways.



Since it took over 300lb of force to get off, I torque the bolt back down to 180ft/pounds just like the FD motor.



Is over torquing this bolt bad? I didn't remember to check the end float just to check.

The engine is in the car but it should be too bad to check again.



C

Wouldn't worry about it.



B

Thanks Brian.



There is nothing like working on 2 projects at the same time and keeping it straight.

Ain't that for dang sure. https://www.nopistons.com/forums/pub...IR#>/blink.gif

Three, for me. Uhg.

The FD bolt is larger than the FC bolt, yes?



I'd torque it to the spec that matches the bolt size.