fc3sboy1

hello , i dont know if this is the proper place to post this but i figure i am building an engine so i guess this was the closest thing.



im building a 13bttre cosmo motor right now and i am in need of a top feed primary fuel rail with -AN fittings and a secondary rail to fit 1600cc injectors, though i only will be running 1200cc inj. but there based off the larger 1600cc units. i was using the 1200s on the s5 and needed a k2rd rail for the 1600cc inj cause of the size of the bodies, anyways with that said does anyone know where i can buy good rails for the cosmo motor and manifold, the k2 rail i already have wont work , the mounting holes are off as well as the spacing of the injectors aswell.



now the motor i am putting together is a combination of an 13bttre cosmo with s5 ported rotor housings and an s4 frount cover with mechanical metering oil pump and s6 motor mounted coil packs and it is all going into my 89 fc. now hows that for an odd combination lol anyone else ever put that combo together for an fc or any rx for that matter, just tryin to see if this is common.



will be wireing up the new wolf 3d 4.0 soon as i finish building the motor as well. ok so that wasnt relivant but its all new stuff for me so i got to tell someone as most of my freinds are into hondas they dont understand my line of thinking but i figure yall will.



also does anyone know if that stone racing manifold for the fd will fit my fc chassis with out having any clearance problems with the frame or sub frame as i need to ditch my hks cast t4 manifold cause the waist gate now hits the motor mounts needed to install the cosmo/s6 motors into the fc cars.



does anyone know if the greddy tb elbow is 3" id cause im lookin for a 3" id tb cover for my ic piping i run.



so to make that long story short need to find good fuel rails and good manifold' and is the greddy elbow 3" id?

and here is a pic of the new beast , the irons will be painted black tomorrow , i just stacked it to check clearances on the manifold to mount and to see what it would look like, what do yall think.

13BTNOS

All your fuel needs http://kgparts.com/newfuel.htm Keith the owner is great person to deal with great customer service.

fc3sboy1

thanks , i was begining to think noone was goin to help out with the rail question, i guess i should have made the link smaller